The working process of the crawler shot blasting machine

02 14 2022

Crawler type shot blasting equipment is widely used in surface cleaning of small and medium-sized batch workpieces, with excellent performance and reliable quality. Because of its speed, high efficiency and thorough cleaning, it is an ideal equipment for cleaning the residual molding sand on the surface of various batches of medium and small castings, and for cleaning the surface oxide scale of forgings and heat-treated parts. Rolling of rubber or steel tracks allows for thorough cleaning of all surfaces of the part. Crawler-type shot blasting equipment can efficiently clean medium-sized workpieces and achieve high output. Crawler shot blasting equipment is suitable for foundry and many other industries. The mass range of the cleaned batch workpieces is 180kg~1360Kg.

The working process of the crawler type shot blasting cleaning machinery and equipment; the projectiles are successively added to the crawler type shot blasting cleaning machinery and equipment, and then put into the workpiece, the feeding door is closed, and the drive is ready; , for the pill gate, and start the cleaning work. After the cleaning is completed, turn off the buttons in sequence: the pill feeding gate, the shot blasting machine, the hoist, the dust collector fan, and then start the rapping motor to clean the dust. After a certain time, the rapping stops. Lift the tooling and workpiece out. In case of emergency, press the emergency stop button, and all the crawler shot blasting machinery and equipment will stop working immediately. After all work is completed, the dust collector should be closed in time. One butterfly valve, and two butterfly valves can be adjusted according to the situation, and a good separation effect can be obtained. There are three kinds of projection speeds for the crawler type shot blasting cleaning machinery.