1. Check whether there are sundries falling into the machine, and clean it up in time to prevent equipment failure caused by clogging each conveying link.
2. Before working, check whether the screws of the accessories of the shot blasting machine are tightened.
3. Before the operation of the pass-through shot blasting machine, it is necessary to check the wear of the wearing parts such as guard plates, blades, impellers, rubber curtains, directional sleeves, rollers, etc., and replace them in time.
4. Check the coordination of the moving parts of the electrical appliances, whether the bolt connection is loose, and tighten it in time.
5. Regularly check whether the oil filling of the spare part meets the regulations at the oil filling point of the shot blasting machine.
In addition, in the environment of high temperature and high humidity, the motor, blade, reducer, etc. are easy to generate heat when the pass-through shot blasting machine is used, and the temperature of the air itself is high, and it is difficult for the accessories of the pass-through shot blasting machine to dissipate heat. , the consumption of accessories will increase exponentially. Since the pass-through shot blasting machine itself is in a humid, rainy and hot environment, the electrical components of the pass-through shot blasting machine will be seriously aged and easily short-circuited, which requires special attention. The steel grit used in the pass-through shot blasting machine is easy to rust in a humid environment, and the rusted steel grit is easy to damage the screw and the hoisting belt of the pass-through shot blasting machine during use.